|
|
Deluxe Magna-Spot Weld Kit
|
$299.00
Professionally remove dents in hoods, fenders, deck lids, or any other sheet metal panel on your car, truck, or tractor. Simply plug Magna-Spot into 115 volt 15 amp outlet, insert draw pin into stud gun, hold against clean metal surface, and press trigger for 1/2 to 1 second. Instantly, Magna-Spot welds draw pin to metal surface where it can be pulled out using slide hammer supplied in kit. Once dent is pulled, grind off draw pin flush with metal surface, and finish with body filler. For large dents, several pins can be welded in a series.
Moulding trim rivets for holding aluminum, stainless, or plastic trim clips can also be welded using the rivet electrode and rivets (included). Insert trim rivet into stud gun, place against clean metal surface until outer ring is seated, press trigger for 1/2 to 1 second; and rivet will now be welded to metal. After painting, plastic or metal trim clips will slide over rivets and hold your trim in place.
Shrink high spots and expand small dents by using the shrink/expand electrode (included). Place Magna-Spot Gun against clean metal surface until outer ring is seated, press trigger for 1/2 second, two or three times to heat metal. Generally, small high spots will disappear. If high spot does not shrink, tap lightly with body hammer. If a dent does not expand, apply a damp cloth to the heated metal to raise the surface.
Includes Magna-Spot 1500 Gun, heavy-duty slide hammer, moulded carrying case, one of each above electrode, 500 2.0mm draw pins, and 150 rivets. Ship wt: 20 lbs. 10-3/4" long, 9" high, 4-1/4" wide. Made in USA.
|
|
|
|
|
|
|
|
Heavy, oversize, motor freight, or other items requiring extra shipping/packaging have a "Zone Adder".
|
 |
Adders for Zone 1, 2, and 3 (if any) are shown above.
See
Shipping/Export for more information and to
determine your delivery zone.
(Direct lines only - no interlines)
This amount will be added to your total automatically.
|
|