For ultimate dent removal, moulding rivet installation, and shrinking/expanding metal!
Remove dents professionally in hoods, fenders, deck lids, or any other sheet metal panel on your car, truck, or tractor. Simply plug Magna-Spot into 115 volt 15 amp outlet, insert draw pin into stud gun, hold against clean metal surface, and press trigger 1/2 to 1 second. Instantly, Magna-Spot welds draw pin to metal surface where it can be pulled out using slide hammer supplied in kit. Once dent is pulled, grind off draw pins flush with metal surface, and finish with body filler. For large dents, several pins can be welded in a series as shown.
Moulding trim rivets for holding aluminum, stainless, or plastic trim clips can also be welded using the optional rivet electrode and rivets shown below. Insert trim rivet into stud gun, place against clean metal surface until outer ring is seated, press trigger for 1/2 to 1 second, and rivet will now be welded to metal. After painting, plastic or metal trim clips will slide over rivets and hold your trim in place.
Shrink high spots and expand small dents by using the optional shrink/expand electrode. Place Magna-Spot Gun against clean metal surface until outer ring is seated, press trigger for 1/2 second, two or three times to heat metal. Generally, small high spots will disappear. If high spot does not shrink, tap lightly with body hammer. If a dent does not expand, apply a damp cloth to the heated metal to raise the surface.
Includes Magna-Spot 1000 Gun, slide hammer for pulling dents, one draw pin electrode and 100 2.0mm draw pins. Ship wt: 17 lbs. 10" long, 9" high, 4-1/4" wide.