Fluid Film Lubricant & Rustproofing Material - Gallon

It's a wax and grease remover

Gun is well constructed. Wands curl up after putting in hole hardly usable

I just used this gun today to rustproof a 2013 Ford F-150 with LPS 3. It worked about as expected. My air compressor is underpowered for the gun (8gal, 2hp, 5.5cfm), but it worked pretty good, just had to work the trigger a bit. It's a budget-friendly gun that meets minimum requirements. The wands worked well too. My only complaint is that they are stiff and hard to bend, but they worked.

I would have given it 5 stars...more on that at the end.This Rustproofing Gun is far superior to the one I had been using in the past. The quick change fittings are nice and small and work well. The trigger seems to be a two-stage trigger. The first stage applies a thin mist and if you want an extra dose of material, pull the trigger all the way in to the second stage. There is an adjustable trigger travel limiting screw (I think that is all it does).The wand with handle is great. The crevice nozzle is fine for what it is designed for, but I needed to get into the underside of the fender panel (from the A pillar) and the nylon hose just curls making that impossible. So I will be making a 36 inch long rigid steel wand for that purpose. I just need to source the quick release fitting.The gun does not leak as my other one did.I'd buy one again.

I bought two, because I need one mask for dust and one for paint. I don't have to switch filters which is time consuming. I just switch masks.

The mask doesn't filter the fumes completely, it may be to small for my face which is probably my fault for ordering the wrong mask.

fits good, reasonably priced.

Just painted a Farmall tractor and this provided a great safety measure.