Bill Hirsch Miracle Solvent

I used this to bond fiberglass nose to metal fenders that was 6 years ago and holding like ,just done. I try to keep extra quat on hand ,don't want to run out!!!

I restore and RV's and have bee using this product for 5 years. If you want a paint that's bullet proof and stops rust. This is the best product you can find. I applied it to the exterior 100 gallon gas tank on a 1995 motorhome over 4 years ago and it still looks like I applied it yesterday.

I use this on antique tractor parts after I have media blasted them clean. This sometimes leave some rust in very small pits. I then etch the part, let it dry, and then brush the paint. Since I am doing small parts, I only need a little paint at anytime. I have used a similar product but the product often solidifies in the can after a few uses. I am amazed that this has not happened to Bill's miracle paint. After removing the cover, which you are not supposed to do, I have used this product over and over by keeping the paint in my shop refrigerator. I then 400 grit sand the body panels, prime, and paint. It leaves a very smooth surface with the small pits covered.

It is frankly amazing. Got rust? Use it.

I bought two, because I need one mask for dust and one for paint. I don't have to switch filters which is time consuming. I just switch masks.

The mask doesn't filter the fumes completely, it may be to small for my face which is probably my fault for ordering the wrong mask.

fits good, reasonably priced.

Just painted a Farmall tractor and this provided a great safety measure.